Manualsbrain.com
  1. 매뉴얼
  2. 브랜드
  3. Alcatel Carrier Internetworking Solutions
  4. Switch/Router
  5. 사용자 설명서

Alcatel Carrier Internetworking Solutions Switch/Router 사용자 설명서

다운로드
페이지 중 1100
 General User Interface Guidelines
Page 4-19
Configuring More Mode for the User Interface
Enabling More Mode
The more mode allows you to specify the maximum number of lines that will be scrolled to 
your workstation’s display. However, before you can specify the maximum number of lines 
that can be displayed, you must first verify that the more mode is enabled. To enable the 
more mode, type 
uic 
at the user prompt and press 
<Enter>
. A screen similar to the following 
will be displayed.
UI Configuration
1)  Prompt  :  ‘$Menu-Path% ’
2) More 
:  off
21) Lines 
:  22 lines
3) Verbose  :  off
4) Timeout  :  5 minutes
Command {Item=Value/?/Help?Quit?Redraw?Save} (Redraw)  :
Next, type 
2=on
 at the submenu prompt and press 
<Enter>
. The screen will be redrawn. Note 
that more mode is now set to 
on
.
UI Configuration
1)  Prompt  :  ‘$Menu-Path% ’
2) More 
:  on
21) Lines 
:  22 lines
3) Verbose  :  off
4) Timeout  :  5 minutes
Command {Item=Value/?/Help?Quit?Redraw?Save} (Redraw)  :
The switch’s default output display is 22 lines. If you want to change this value, type 
21=
, 
followed by the maximum number of lines to be displayed, and press 
<Enter>
. For example:
21=50.
After you press 
<Enter>
, the screen will be redrawn. Note that the output display value at line 
21 of the 
uic
 submenu has been changed.
UI Configuration
1)  Prompt  :  ‘$Menu-Path% ’
2) More 
:  on
21) Lines 
:  50 lines
3) Verbose  :  off
4) Timeout  :  5 minutes
Command {Item=Value/?/Help?Quit?Redraw?Save} (Redraw)  :
Be sure to type 
save
 at the submenu prompt and press 
<Enter>
. More mode is now enabled. 
Changing the More Mode Line Value
If the switch’s more mode has already been enabled and you want to change the maximum 
number of lines to be displayed on your workstation, type 
uic 
at the user prompt and press 
<Enter>
.