Alcatel Carrier Internetworking Solutions Switch/Router 사용자 설명서

Page 6-20

The 

 command displays or alters the swap state of the chassis. The swap state must be 

on in order to hot swap modules. If not, the system may halt or restart. While the swap state 
is on, performance may decrease. Therefore, the swap state should only be turned on when 
you want to hot swap modules. See Chapter 3, “Omni Switch/Router Switching Modules,” for 
instructions on hot swapping a switching module.

To display the current swap state of the chassis, enter

at the system prompt. If the swap mode is 

 (the default for the switch), something similar 

to the following will be displayed.

If the swap mode is 

, something similar to the following will be displayed.

The swap mode must be enabled (

) to hot swap a switching module. If not, the system 

may halt or restart. See the subsection below for instructions on enabling the swap mode.

To turn the swap mode 

, enter

at the system prompt. (The default for swap mode is 5 minutes). Something similar to the 
following will be displayed.

When you turn the swap state on, you set a timer which determines how long the system will 
remain in swap state. After the timer expires, the system will automatically turn off the swap 
state.

If you want to vary the amount of time that the swap mode is enabled, enter 

 

followed by the number of minutes you want the swap mode enabled. You can set the swap 
state from 1 to 227,055 minutes. To set the swap mode on for 10 minutes, for example, enter

at the system prompt. The following will then be displayed.

Press 

 and then press 

 to save the new value. If you don’t want save, just press 

 and the default value will not change. You can also turn off the swap immediately as 

shown in Disabling the Swap Mode on page 6-21.