Alcatel Carrier Internetworking Solutions Switch/Router 사용자 설명서

Page 9-33

Under normal conditions, configurations you make using the UI are written into cache and 
automatically saved into the switch’s flash memory. In this case, it is not necessary to issue a 
special command to save your configurations. When you use the UI to enter multiple configu-
rations, periodically the switch will display the following message.

This message indicates that the switch is compacting data in the cache buffer before writing it 
into the mpm.cnf file. This message normally disappears after a few seconds. 

♦ Warning ♦

It is highly recommended that you use the default 
setting and allow the switch’s save function to operate 
automatically.

You can change the switch’s save function so that the cache is not saved automatically by 
executing the 

 command. To turn off the switch’s automatic save function, enter

at the system prompt. The following message will display.

♦ Warning ♦

Any configurations you enter before executing the 

 command will not be saved in case of 

system failure or reboot.

Once 

is implemented, you must use the 

 command to manually 

synchronize your configurations into flash memory. When you execute the 

 

command at the system prompt, the following message will display.

The UI does not indicate when the 

 function is in operation. However, if you 

attempt a reboot the following message will display if you are in the cache configuration 
mode.

This message gives you the opportunity to execute the 

 command prior to the 

reboot.