Alcatel Carrier Internetworking Solutions Switch/Router 사용자 설명서

Page 15-3

Kodiak-based modules will flood packets with unknown destination addresses on ports 
configured for optimized device mode. To prevent this condition, the following command can 
be entered into the 

 file:

If the port is set to optimized and has not learned a MAC address, it will flood these packets 
out regardless if the above condition is used. If the above flag is set, the port will not flood 
multicast packets.

♦ Note ♦

For information on editing the 

text files, see 

Chapter 7, “Managing Files.”

Ethernet10BaseT, 10/100BaseT and 100BaseF boards can detect certain cabling errors and/or 
physical media misconfigurations which could lead to multiple retries or reception of multi-
ple spurious frames, affecting performance of attached devices. In this event, the system will 
partition the affected port, which will be marked in the 

 menu with Inactive (

) opera-

tional status. (See Chapter 19, “Managing Groups and Ports,” for information about the 

 

command.) If a cable drop is detected, the system will remove the partitioned state, bringing 
the port back into a normal state once the link is detected. 

If the original cabling problem has not been corrected, the link may become partitioned 
again. In this event, normal operation will be enabled when the problem has been corrected.

ESX-K-100C-32W
(Omni Switch/Router)

10/100 Mbs

Yes

10/100cfg

10/100vc

Yes

ESX-K-100FM/FS-16W
(Omni Switch/Router)

100 Mbs

Yes

10/100cfg

10/100vc

Yes

GSX-K-FM/FS-2W
(Omni Switch/Router)

1000 Mbs

Yes

10/100cfg

10/100vc

No