Alcatel Carrier Internetworking Solutions Switch/Router 사용자 설명서

Page 16-18

802.1Q groups for both 10/100 and Gigabit Ethernet ports can be deleted using the 

 

command. The procedure is slightly different in each case.

To delete an 

802.1Q

 group from a 10/100 port using single spanning tree, use the 

 

command, as shown:

where 

 is the slot number of the module on the switch, 

 is the port number where 

the service was created, 

 is the identifier for the service on this port, and 

 

is the number of the group that the port belongs to. For example, to delete an 

802.1Q

 service 

for group 2, instance 1 on port 5 of slot 2, enter:

To delete 

802.1Q

 groups from a Gigabit port or 10/100 ports using multiple spanning tree, 

enter the 

 command, as shown:

 

where 

 is the slot number of the module on the switch, 

 is the port number where 

the service was created, and 

 is the identifier for the service on this port. For exam-

ple, to delete 

802.1Q

 service instance 1 on port 5 of slot 2, enter:

In either case, a message will appear, confirming the delete operation:

♦ Important Notes ♦

You must delete X802.1Q groups in the same order on 
both ends of the link. For example, if you delete 
groups 1, 2, 3, 4, and 5 on the local switch, you must 
delete the same five groups in the same order on the 
remote switch. If groups are not deleted in this manner, 
X802.1Q packets will not be routed correctly.

To delete 

802.1Q

 support over OmniChannel, you must 

first delete the 

802.1Q

 service before you delete the 

OmniChannel.