Alcatel Carrier Internetworking Solutions Switch/Router 사용자 설명서

Page 19-38

The 

 command provides information on all currently defined Groups in a switch including 

Group number, network address, protocol type, and encapsulation type. You can obtain 
information on all groups in a switch by entering:

A screen similar to the following displays:

You can also get information on a specific Group by entering 

 followed by the Group 

number. For example,

displays information just on Group 3:

The following sections describe the columns in this table:

. The identification number assigned to this Group when it was created 

through the 

 command. The Group identifier is typically consistent network-wide (i.e., 

Group 3 in this switch should be the same Group as Group 3 configured in all other Omni 
Switch/Routers in the network). If this Group contains any 

VLAN

s, then they will be listed 

below the Group number. If the default VLAN in the Group supports both IP and IPX rout-
ing, then information on both (network address, etc) will display. Group 4 in the screen 
sample above shows a case where both IP and IPX routing are supported.

. The textual description of this Group that was entered when the Group was 

created or modified. This description is limited to 30 characters.

. For each virtual router port configured, 

two addresses are listed. Both of these addresses were configured when the Group was 
created or modified through 

 or 

. The first address is the Network Address, which is 

the address of the virtual router port for the default 

VLAN

 (

VLAN #1

) in this Group. For an IP 

virtual router port, this address is the 

IP

 address, which is shown in dotted decimal format. 

For an 

IPX

 virtual router port, this address is the 

IPX

 network address, which is shown as 

eight hex characters.