Alcatel Carrier Internetworking Solutions Switch/Router 사용자 설명서

Defining and Configuring AutoTracker Policies

Page 20-21

Defining a DHCP MAC Address Policy

You can see how DHCP MAC address policies were used in an application example on page
20-27.

After you enter the Administrative Status for this mobile group or AutoTracker

VLAN

, the

following menu displays:

Select rule type:
1. Port Rule
2. MAC Address Rule

21) MAC Address Range Rule

3. Protocol Rule
4. Network Address Rule
5. User Defined Rule
6. Binding Rule
7. DHCP PORT Rule
8. DHCP MAC Rule

81) DHCP MAC Range Rule

Enter rule type (1):

1. Enter

and press

<Enter>

2. The following prompt displays:

Set Rule Admin Status to ((e)nable/(d)isable):

Indicate whether or not you want to enable the Administrative Status for this rule. Type

to enable or

to disable. If you enable the rule, the switch will use it to determine

membership of devices. If you disable the rule, then the switch will not use this rule, but
the parameters you set up will be saved. The Admin Status for a Policy is different from
the Admin Status for the mobile group or AutoTracker

VLAN

as it applies only this specific

rule. You can enable or disable the rule at a later time using the

modatvl

command.

3. The following prompt displays:

Enter the list of MAC addresses (AABBCC:DDEEFF) in Canonical format
(Enter save to end):

Enter the

MAC

addresses that you want to include in this mobile group or AutoTracker

VLAN

. Separate addresses by a space. When you have entered the final

MAC

address, leave

a space and type

save

4. The following prompt displays:

Configure more rules for this vlan (y/n):

You can set up multiple rules for the same mobile group or AutoTracker

VLAN

. Enter a

here if you want to set up more rules in addition to the port rule specified here. If you
enter

, you will be prompted for the next rule that you want to set up. Follow the direc-

tions in the appropriate section to configure that rule.

If you enter

, you will receive a message, similar to the one below, indicating that the

VLAN

was set up.

VLAN 1:2 created successfully

You are done setting up rules for this mobile group or AutoTracker

VLAN