Alcatel Carrier Internetworking Solutions Switch/Router 사용자 설명서

Page 3-4

All switching modules can be inserted and removed from the switch chassis while power is 
on or off without disrupting the other modules. A standard screwdriver is required for install-
ing and removing switching modules. You can also hot swap modules of the same type while 
the switch is active.

Switching modules may be installed in any slot other than Slot 1. (Slot 1 is reserved for an 

MPX

.) In a setup with redundant 

MPX

 modules, Slots 1 and 2 are reserved for the 

MPXs

. Addi-

tional modules can be installed in any available slot. (OmniS/R-3 slots are numbered 1 to 3 
starting from the topmost slot. OmniS/R-5 slots are numbered 1 to 5 starting from the topmost 
slot. OmniS/R-9 slots are numbered 1 to 9 starting from the left.)

♦ Anti-Static Warning ♦

Before handling a switching module, free your hands 
of static by wearing a grounding strip, or by grounding 
yourself properly. Static discharge can damage the 
components on the switching module.

To insert a switching module follow these instructions:

1. Holding the module firmly in both hands, carefully slide it into the card guide. The front 

panel connectors and 

LED

s should face outward. In a 9-slot Omni Switch/Router, the 

component side of the board should face right (toward the power supply). In a 3- or 5-
slot Omni Switch/Router, the component side should face up.

The module should slide in easily. A large amount of force is not necessary and should 
not be used. If any resistance is encountered, check to be sure that the module is aligned 
properly in the card guide.

Switch Module

Card Guides

Slide Card In