Alcatel Carrier Internetworking Solutions Switch/Router 사용자 설명서

Page 25-31

The 

 command is used to find the IP route from the local switch to a specified IP 

address destination. This command displays the individual hops to the destinations as well as 
some timing information. When using the 

 command, you must enter the name of 

the destination as part of the command line.

As an example, we might want to trace the route to “corporate.com.” To do so, we would 
enter this command:

A screen similar to the following displays:

Each number displayed corresponds to an individual hop. The time needed to reach that hop 
is shown (in milliseconds) after the hop’s IP address. The time may be followed by one of the 
following codes:

The TTL of the received ICMP message is less than or equal to 1.

The host was unreachable.

The network was unreachable.

The protocol was unreachable.

If the time is replaced by an asterisk (

), no response was received from the host during the 

default 3-second timeout period.