Alcatel Carrier Internetworking Solutions Switch/Router 사용자 설명서

Page 26-17

At least one next-hop address (or a forwarding 

VLAN

 as described in Forwarding VLANs for 

To add a next-hop address for 

NBDD

 relay:

1. At the command prompt for the UDP Relay Configuration screen, enter the following:

A screen similar to the following displays:

2. Enter the 

IP

 address of the next hop. Enter the address in dotted decimal format (i.e., 

198.206.181.12), a hexadecimal address (i.e., 0xc6ceb501). A host name (i.e., system.com) 
may be entered if the 

DNS

 resolver is enabled using the 

 command.

♦ Note ♦

This address may be the unicast address of the server 
or a subnet broadcast address of the subnet where the 
server is located. Using a unicast address is not recom-
mended because an 

NBNS

 by definition may shift part 

or all of its responsibility to another node in the 
network segment.

3. Enter any additional addresses up to a maximum of 8. Press 

 to return to the UDP 

Relay Configuration screen.

4. Enter 

 to save the changes.

To delete next-hop addresses for the 

NBDD

 relay:

1. Enter 

 at the command prompt of the UDP Relay Configuration screen. The 

FORWARD TO Server List displays.

2. Enter the item number that corresponds to the entry that you want to delete. Repeat this 

step to delete any additional entries.

3. Press 

 to return to the UDP Relay Configuration screen.

4. Enter 

 to save the changes.