Alcatel Carrier Internetworking Solutions Switch/Router 사용자 설명서

Page 28-27

The number of 100 millisecond increments between generated echo message requests. This 
only displays if the port is using PPP as its encapsulation type. The valid range is 0-255.

Sets the transition time between proprietary messages sent over the link. These messages are 
analyzed to determine whether the link is in a loopback state. This only displays if the port is 
using Frame Relay as its encapsulation type. The valid range is 0-255.

You can view all current parameters for a 

WSX

 port or an individual virtual circuit using the 

 command. These parameters will be either the default parameters or parameters you 

modified using the 

 command or network management software.

You have a choice of viewing parameters at the chassis, slot or port level. You receive 
different configuration choices depending upon which level you choose. The sections below 
describe both ways to use the 

 command.

To view port parameters for all 

submodule

 boards in a chassis, enter the following command

or

A screen similar to following displays. In this example, the port parameters being displayed 
are for a system that contains a 2-port BRI submodule in slot 3.

This screen lists the current values for the listed parameters. 

For 

, 

 and 

, these parameters are the same as those set through the 

 command. For detailed information on these values, see Modifying a Port on page 

, 

and 

, these parameters are the same as those set 

through the 

 command. See Obtaining Status and Statistical Information on page 28-