Runco VX-6000D 사용자 설명서
66
Runco VX-6000d Installation/Operation Manual
PRE
L
Y
Table 4-2 lists the x- and y-coordinates for each color temperature preset.
to enable (On) or disable (Off) BrilliantColor processing, which improves brightness in
grays and secondary colors.
grays and secondary colors.
setting. RVR lets you control the aperture or iris size (the physical opening through the
lens; similar to an “f-stop” on a camera). Doing so allows you to optimize brightness
and contrast according to the amount of ambient light in the viewing area.
lens; similar to an “f-stop” on a camera). Doing so allows you to optimize brightness
and contrast according to the amount of ambient light in the viewing area.
Use the lower setting (0 = fully open) for rooms with a lot of ambient light. Use the
higher setting for more “theater-like” viewing conditions (little or no ambient light).
Input Image: The Input Image controls are functionally similar to those in the Picture
menu (refer to page 56), but are accessible only by entering the Calibration menu
passcode.
menu (refer to page 56), but are accessible only by entering the Calibration menu
passcode.
Input Color: The Input Color controls are similar to those in the Display Color menu (see
above), but adjust the color balance of the incoming signal. These settings are also saved
independently for each input and display mode.
above), but adjust the color balance of the incoming signal. These settings are also saved
independently for each input and display mode.
• Gain/Offset (HD1, HD2 and Component/SCART inputs only): These controls
operate similarly to those in the Display Color menu (described on page 64), but affect
the Y, Pb and Pr signal components rather than the red, green and blue channels.
the Y, Pb and Pr signal components rather than the red, green and blue channels.
• Chroma Delay: use the Chroma Delay control to correct a mis-aligned image from a
Composite or S-Video source. Chroma delay in an image causes color shifts to occur
to the left of the vertical edge transitions, producing artificial shadows or a “halo” effect.
If necessary, adjust this setting to eliminate them.
to the left of the vertical edge transitions, producing artificial shadows or a “halo” effect.
If necessary, adjust this setting to eliminate them.
• Noise Filter: To apply noise filtering to the input signal, select Noise Filter from the
Input Color menu. The Noise Filter is useful for clearing up noisy images from 480i
video sources.
video sources.
Use the left- or right-arrow buttons to select the desired amount of noise reduction,
keeping in mind that higher settings (which reduce high frequencies) may also “soften”
the image.
keeping in mind that higher settings (which reduce high frequencies) may also “soften”
the image.
Table 4-2. Color Temperature Presets and Associated Color Points
Color Temperature Preset
Associated x/y Values
x
y
5500K
0.332
0.348
6500K
0.313
0.329
7500K
0.299
0.315
9300K
0.284
0.298
The Input Image settings establish the “zero point” for the Picture
menu settings, whose values represent offsets from the Input
Image settings. For example, if you set Brightness to 10 in this
menu, setting Brightness to 10 in the Picture menu results in an
actual setting value of 20 (10+10).
menu settings, whose values represent offsets from the Input
Image settings. For example, if you set Brightness to 10 in this
menu, setting Brightness to 10 in the Picture menu results in an
actual setting value of 20 (10+10).
Note