Runco VX-60d 사용자 설명서

The projection lens is shipped separately from the projector. Proceed as follows to install 
the projection lens:

1. Remove the lens plug from the lens opening in the projector.

2. Place the lens cap on the projection lens to protect it from being damaged during the 

installation process. 

3. Remove the rear cap from the lens. This protective cap is only used during shipping to 

protect the lens from damage. 

4. Slide the new lens into the lens opening of the projector. Make sure to align the 

connector on the side of the lens with the connector assembly on the lens retaining 
ring; see Figure 3-6. 

 

 
As you connect the lens, you may have to re-align it slightly until the tabs on the lens fit 
into the slots in the lens retaining ring. 

5. With the lens fully inserted (and connected), turn it clockwise until the lens release 

button “pops” indicating the lens is fully inserted.