Runco Vision 85 사용자 설명서

The Vision 85 system includes two (2) AC power cords (one each for the projector and VHD 
Controller).

Plug the female end of one power cord into the AC receptacle on the rear of the Vision 85 (AC 
100V to 240V). Then, connect the other end to your AC power source. Similarly connect the 
VHD Controller to a nearby AC outlet. 

1.

Turn on your source components. 

2.

Turn on the main power switch at the rear of the VHD Controller.

3.

Press the ON button on the remote control – or the POWER (

) button on the VHD 

Controller front panel – to turn on the system. The vacuum fluorescent display on the 
VHD Controller front panel briefly displays “Starting Display.”

4.

When the projector is ready for use, the fluorescent display indicates the active source, 
signal format (NTSC or PAL), input resolution and aspect ratio; for example: 

 

By default, the Vision 85 is configured for a “floor/front” installation, in which the projector is 
installed upright and in front of the screen. If it is installed behind the screen and/or mounted 
on a ceiling, you must change the picture orientation. To do this:

1.

Select an input OTHER THAN HDMI 1 or HDMI 2 on the VHD Controller. 

2.

Press MENU and enter the Service Menu passcode.

3.

Select Service from the Main Menu. 

4.

Select Display Device from the Service Menu, then select Configure.

5.

Press 

, then choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match the installation 

method.

 

➤

Component SD NTSC 

480i

16:9 V85

Current Source

Format

Input

Resolution

Aspect Ratio