Viewsonic A-CD-PJ502 사용자 가이드

NOTE. Turn the power on/off in right order. Please power on the projector before the
connected devices. Power off the projector after the connected devices

1. Make sure that the power cord is firmly and correctly connected to the projector

 and outlet.

2. Remove the lens cover, and set the power switch to the ON position.

The power indicator will light to solid orange. Then wait several seconds because

 buttons 

may not function for these several seconds.

3. Press the STANDBY/ON (on the projector or the remote control) button.

The projector lamp will light up and the POWER indicator will begin blinking green.
When the power is completely on, the indicator will stop blinking light green.
To display the picture, select an input signal according to the section “Selecting

 an input 

signal”.

1. Press the STANDBY/ON (on the projector or the remote control) button.

The message “Power off?” will appear on the screen for approximately 5 seconds.

2. Press the STANDBY/ON (on the projector or the remote control) button again

 while the 

message is visible.
The projector lamp will go off, and the POWER indicator will begin blinking

 orange.

Then the POWER indicator will stop blinking and light to solid orange when the

 lamp cool-

ing is complete.

3. Make sure that the power indicator lights to solid orange, set the power switch to

 the OFF 

position. The POWER indicator will go off.

X When the power is on, a strong light is emitted. Do not look into the lens or vents

 of 

the projector.

POWER
indicator

STANDBY / ON 

button

Power switch

(On position) (Off position)

STANDBY / ON 

button