Sony VPL-AW10 매뉴얼
56
4
Loosen the three screws on the
lamp with the Phillips
screwdriver. Hold up the handle,
then pull the lamp straight out.
lamp with the Phillips
screwdriver. Hold up the handle,
then pull the lamp straight out.
5
Hold the handle of the new lamp
and push it in securely until it
reaches the end, and then
tighten the 3 screws.
and push it in securely until it
reaches the end, and then
tighten the 3 screws.
• Be careful not to touch the optical block
inside the unit.
• If the 3 screws are not tightened
securely, the lamp cover will not close.
6
Close the lamp cover, then
tighten the screws.
tighten the screws.
If the lamp cover is not set securely, the power
will not turn on.
will not turn on.
7
Remove the air filter cover.
8
Remove the air filter.
Notes
Note