Sharp PG-C45X 사용자 설명서

▼Keycode input box

',", \, |
buttons

', ", \, |
buttons

• The language preset at the factory is English.

If you want to change the on-screen display
to another language, reset the language ac-
cording to the procedure on page 

• The power indicator illuminates red, and

the projector enters standby mode.

ON

• The power indicator illuminates green.

After the lamp replacement indicator il-
luminates, the projector is ready to start
operation.

Note

• The lamp replacement indicator il-

luminates, indicating the status of the
lamp.

Green: The lamp is ready.
Green blinking: The lamp is

warming up.

• If the power is turned off and immediately

switched on again, the lamp replacement
indicator may take time to illuminate.

• When controlling the projector using

RS-232C commands from a com-
puter, wait for at least 30 seconds
after the power has been turned on,
and then transmit the commands.

• Enter the keycode.

Note

• When entering the keycode, press

the buttons previously set on the
projector or the remote control.

• When “Anti-Theft” is set, enter the

keycode or the input display will not ap-
pear. Even when the signal is input, the
display will not appear. (see page