Epson EB-940H 사용자 설명서

d

Copy  the  batch  setup  file  (PJCONFDATA.bin)  that  you  saved  to
your  computer  to  the  top  level  folder  of  the  removable  disk.

a

Do  not  copy  any  files  or  folders  other  than  the  batch  setup  file
to  the  removable  disk.

e

Perform   Remove  USB  device  on  your  computer,  and  then
disconnect  the  USB  cable.

a

When  using  OS  X,  perform  Remove  EPSON_PJ.

When   all   of   the   indicators   start   flashing,   the   settings   are   being
written.

Do   not   disconnect   the   power   cord   from   the   projector   while   the   settings
are  being  written.  If  the  power  cord  is  disconnected,  the  projector  may
not  start  correctly.

When  writing  completes  normally,  the  projector  enters  standby
status.

The  indicators  notify  you  if  an  error  occurs.  Check  the  status  of  the
indicators.

Status of the Indicators

Remedy

Lamp: Orange - flashing fast

Temp: Orange - flashing fast

The batch setup file may be corrupt, or the USB
storage device or USB cable may not be connected
correctly. Disconnect the USB storage device or the
USB cable, unplug and then plug in the projector's
power cord, and then try again.

Power: Blue - flashing fast

Status: Blue - flashing fast

Lamp: Orange - flashing fast

Temp: Orange - flashing fast

Writing the settings may have failed and an error
may have occurred in the projector's firmware.
Stop using the projector, remove the power plug
from the electrical outlet, and contact your local
dealer or the nearest address provided in the Epson
Projector Contact List.