Epson 7600p 사용자 설명서
Maintaining and Transporting the Projector
59
Cleaning and Replacing the Air Filter
Clean the air filter at the bottom of the projector after every 100 hours
of use. If it is not cleaned periodically, it can become clogged with
dust, preventing proper ventilation. This can cause overheating and
damage the projector. To clean the air filter, follow these steps:
of use. If it is not cleaned periodically, it can become clogged with
dust, preventing proper ventilation. This can cause overheating and
damage the projector. To clean the air filter, follow these steps:
1. Turn off the projector, allow it to cool down, and unplug the
power cord.
2. Turn the projector on its side so that the handle is on top and you
can access the filter easily.
3. To clean the filter, EPSON recommends using a small vacuum
cleaner designed for computers and other office equipment. If you
don’t have one, gently clean the filter using a very soft brush (such
as an artist’s camel-hair brush).
don’t have one, gently clean the filter using a very soft brush (such
as an artist’s camel-hair brush).
4. If the dirt is difficult to remove or if the filter is torn, replace it.
Contact your dealer or call EPSON at (800) 873-7766 in the
United States and Canada to obtain a new one.
United States and Canada to obtain a new one.
Before removing the filter, make sure the projector is on its side as
shown (not upside down) to prevent dust from falling inside.
Then release the latch to remove the filter.
shown (not upside down) to prevent dust from falling inside.
Then release the latch to remove the filter.
latch
note
When you get a replacement
lamp for your projector, a
new air filter is included.
You should replace the filter
when you replace the lamp.
lamp for your projector, a
new air filter is included.
You should replace the filter
when you replace the lamp.
5600 and 7600.book Page 59 Thursday, December 14, 2000 2:46 PM