Epson 7800p 사용자 설명서

다운로드
페이지 22
EPSON PowerLite 7800p Projector
20
 -
 EPSON PowerLite 7800p Projector
5/03
Follow these steps to replace the lamp and air filters:
1. Turn off the projector.
2. When the P power light stops flashing, unplug the power 
cord.
3. Let the projector cool for at least half an hour (if it has been 
on). The lamp is extremely hot immediately after use. 
4. Turn the projector upside-down and remove the air filters 
at the side and bottom of the projector.
5. Insert the two new air filters. They should click into place.
6. To remove the lamp cover, insert the screwdriver supplied 
with the spare lamp (or another flat-tipped screwdriver), 
into the space beside the air vent to gently lift the lamp 
cover off.
7. Loosen the two screws holding the lamp in place. (You 
don’t need to remove them.) 
8. Grasp the wire handle as shown and pull the lamp straight 
out. 
9. Gently insert the new lamp. 
10. Once the lamp is fully inserted, tighten its screws and 
replace the cover. (The projector won’t come on if the lamp 
cover is loose.) 
11. Reset the lamp timer as described in the next section. 
Resetting the Lamp Timer
After you replace the lamp, you need to reset the lamp timer 
using the projector’s About menu. 
1. Press the 
Menu
 button on the remote control or the 
projector’s control panel to display the main menu.
2. Use the 
pointer button on the remote control (or the 
arrow buttons on the projector) to highlight 
About
, then 
press 
Enter
Slide the filter 
up here . . .
. . . and here
Lower the 
handle
1
Insert the screwdriver here