Epson 745c 사용자 설명서

Epson PowerLite 745c Projector

8/04

Epson PowerLite 745c Projector 

- 

5

If multiple devices are connected to the projector, the easiest 
way to select the image source is to press the 

Search

 button on 

the remote control or the 

Source Search

 button on the 

projector until the correct image is projected.

You can also press one of the following buttons on the 
remote control:
❏

Computer 

to select the device connected to the projector’s 

Computer/Component Video 

port. 

❏

S-Video

 to select the device connected to the 

S-Video

 port.

❏

Video

 button to select the device connected to the 

Video

 port.

❏

EasyMP

 button to project wirelessly or from a memory 

card.

After you select a source, the screen goes dark for a moment 
before the image appears. 

Once you see your image, you may need to make certain 
adjustments, as described in this section.

Rotate the focus ring to sharpen the image.

Rotate the zoom ring to reduce or enlarge the image.

You can also change the image size by moving the projector 
closer to or farther away from the screen. You can use the 

E-Zoom

 buttons on the remote control to zoom in on a portion 

of the image. See “Zooming Your Image” on page 7 for 
instructions. 

If the image is too low, you can raise it by extending the 
projector’s front adjustable foot. 

1. Stand behind the projector. Press up on the blue foot release 

lever and lift the front of the projector to extend the front 
adjustable foot.

2. Once the image is positioned where you want it, release the 

lever to lock the foot in position.

3. If the projector is not level, rotate the 

foot at the back of the projector.

If the image is no longer rectangular after 
raising it, see the next section.

If you’ve connected a computer and the image doesn’t look 
right, or it doesn’t fit properly on the screen, press the 

Auto

 

button on the remote control or the 

Enter

 button on the 

projector. This automatically resets the projector’s tracking, 
sync, resolution, and position settings. You must be projecting 
an image for this button to have any effect. Additionally, if the 

Auto Setup

 option in the Signal menu is set to 

OFF

, the Auto 

function will not work.

Focus ring

Zoom ring