Epson 31000 사용자 설명서

Making Detailed Adjustments

3. Do one of the following:

■

Select 

Reset All 

to return all projector settings to their original defaults (except 

Component, Memory, Language, Network, and Lamp).

■

Select 

Reset Memory

 to clear all memory settings.

■

Select 

Reset Lens Position

 to clear all lens position memory settings.

■

Select 

Reset Lamp Hours 

to clear the lamp usage timer and reset it to zero. 

You should reset the lamp timer only when you install a new projector lamp. See 
page 59 for more information.

Use the settings in this section to adjust the image size and position, suppress on-screen text, 
and select basic setup options.

Before adjusting any of these settings, make sure you have already selected an appropriate 
aspect ratio for the type of picture you’re viewing (see page 26). 

■ Overscan

For component video formats, this setting lets you see the edges of the image that are not 
normally visible in the picture. If you see interference when you set 

Overscan

 to 

Off

, try 

adjusting the 

Position

 as described below. 

■ Position

Note: This setting cannot be used with a signal input through the HDMI 1 or HMDI 2 port.

Use the arrow buttons to fine-tune the position of the image on the screen.

■

Aspect

This setting lets you change the aspect ratio of your image, and works the same as 
pressing the 

Aspect

 button on the remote control. See page 26 for more information.

Signal > Advanced > Overscan

Signal > Position

Signal > Aspect