Epson EMP-TW600 사용자 설명서
45
Maintenance
Appe
ndix
Replacing the lamp
c
Caution:
•
Install the lamp and the lamp cover securely. The lamp will not turn on if the
lamp or the lamp cover is not installed correctly.
lamp or the lamp cover is not installed correctly.
•
This product includes a lamp component that contains mercury (Hg).
Please consult your state and local regurations regarding disposal or recycling.
Do not put in the trash.
Please consult your state and local regurations regarding disposal or recycling.
Do not put in the trash.
Remove the old lamp.
Pull out straight.
1
c
Caution:
If the lamp stops working
and needs to be
replaced, there is the
danger that the lamp may
already be broken.
If replacing the lamp of a
projector which has been
installed to the ceiling,
you should always
assume that the lamp is
broken and handle it with
extreme care during
removal. Furthermore,
you should stand to the
side of the projector, not
underneath it.
and needs to be
replaced, there is the
danger that the lamp may
already be broken.
If replacing the lamp of a
projector which has been
installed to the ceiling,
you should always
assume that the lamp is
broken and handle it with
extreme care during
removal. Furthermore,
you should stand to the
side of the projector, not
underneath it.
2
Remove the lamp cover.
Press
or
to turn
the power off, wait until
the projector cools down ,
and then turn off the main
power switch.
the projector cools down ,
and then turn off the main
power switch.
* Wait until the lamp
cools down (takes
approximately 1 hour).
approximately 1 hour).
6
7
Install the lamp cover.
Securely tighten the
lamp fixing screws.
lamp fixing screws.
1
2
1
2
3
4
Loosen the lamp fixing
screws.
screws.
5
Insert the new lamp.
Make sure that it faces
the correct way.
the correct way.