Epson 5600p 사용자 설명서

다운로드
페이지 114
32
Using the Remote Control
Installing the Batteries
Follow these steps to install the remote control’s batteries: 
1. Press the tab to release the 
battery compartment cover.
2. Remove the cover and insert 
the two AA batteries included 
with the projector as shown.
3. Replace the battery 
compartment cover.
Before you can use the remote 
control, you need to turn it on as 
described below.
Turning On the Remote Control
Make sure the batteries are installed. Then push up the on/off switch 
on the side of the remote control to turn it on.
If you want to make sure the batteries are good, press the round 
light button. The other buttons on the remote should light up 
temporarily. If they don’t, you need to change the batteries as 
described above.
Turn off the remote control before transporting it or storing it with 
the projector in a carrying case; this prevents the batteries from 
discharging if something presses against one of the remote control’s 
buttons.
caution
When replacing batteries, 
take the following 
precautions:
Don’t mix old and new 
batteries.
Replace batteries as soon as 
they run out. If the 
batteries leak, wipe away 
battery fluid with a soft 
cloth. If fluid gets on your 
hands, wash them 
immediately.
Remove batteries if you 
won’t be using the remote 
control for a long time.
tab
Power
Freeze
A/V Mute
E-Zoom
R/C ON
OFF
3
1
5
2
4
Enter
Esc
on/off 
switch
light 
button
5600 and 7600.book  Page 32  Thursday, December 14, 2000  2:46 PM