Epson 5600p 사용자 설명서
Connecting to Additional Equipment
83
Connecting to a Desktop Macintosh
You can connect the projector to any desktop Macintosh. This section
includes instructions for the following:
includes instructions for the following:
■
Connecting the computer cable
■
Connecting the mouse cable (if you want to use your remote
control as a mouse)
control as a mouse)
■
Connecting the audio cable (if you’ll be projecting with audio)
Follow the steps in each section for the cables you need to connect.
Before beginning, make sure the projector and computer are turned
off. If you need help with positioning the projector, see page 10.
Before beginning, make sure the projector and computer are turned
off. If you need help with positioning the projector, see page 10.
Connecting the Computer Cable
1. Disconnect the monitor cable from the video port on the back of
the Macintosh and set it aside. (You won’t be able to use the
monitor while the projector is connected.)
monitor while the projector is connected.)
2. Connect one end of the computer cable to the projector’s
Computer 1
port, as shown.
3. Connect the other end of the computer cable to the video port on
the Macintosh. If it doesn’t fit, you may have to use a Macintosh
desktop adapter, which you can buy from EPSON (see page 8).
desktop adapter, which you can buy from EPSON (see page 8).
note
Macintosh configurations
vary. See your computer
manual for the location of the
ports needed to connect your
projector. Older models may
require a Macintosh adapter
set, which you may purchase
from EPSON; see page 8.
vary. See your computer
manual for the location of the
ports needed to connect your
projector. Older models may
require a Macintosh adapter
set, which you may purchase
from EPSON; see page 8.
Macintosh desktop
adapter (if needed)
adapter (if needed)
computer cable
Computer 1 port
5600 and 7600.book Page 83 Thursday, December 14, 2000 2:46 PM