Epson ELPMBPRG 사용자 설명서

ISSUED: 04-01-08  SHEET #: 055-9254-2

Visit the Peerless Web Site at www.peerlessmounts.com

For Technical Support Contact Peerless Mounts at 1-800-729-0307 or 708-865-8870.

To adjust yaw (swivel) for extension column installation:  Loosen screw on projector mount assembly (A)
indicated below until projector mount can be rotated.  Rotate mount to desired position and retighten screw.

To adjust pitch (forward and backward tilt):  Turn knob on back of mount as shown below. Pull knob out and turn
by hand for easy adjustment or insert #2 phillips screwdriver in end of knob and turn.

To adjust roll (side to side tilt):  Turn knob on side of mount as shown below. Pull knob out and turn by hand for
easy adjustment or insert #2 phillips screwdriver in end of knob and turn.

SCREW  FOR  SWIVEL  STOP

KNOB  FOR  ROLL
ADJUSTMENT

KNOB  FOR  PITCH
ADJUSTMENT

BACK OF MOUNT

To prevent tampering with the pitch and roll adjustments:  Tighten the two tamper resistant security screws
on the projector mount assembly using 4 mm security allen wrench (J) to lock the pitch and roll adjustments as
shown below.
NOTE: Tighten screws firmly, but do not overtighten. Overtightening can damage the mount.

• Do not adjust pitch or roll while tamper resistant security screws are fully engaged.
• Loosen the two tamper resistant security screws one complete turn before adjusting the projector mount assembly or

damage may occur.

TO LOCK ROLL TIGHTEN
TAMPER  RESISTANT
SECURITY  SCREW

TO LOCK PITCH TIGHTEN
TAMPER  RESISTANT
SECURITY  SCREW

ARROW INDICATES
FRONT OF MOUNT

7

7-1