Epson EMP-505 / 715 사용자 설명서

 Troubleshooting - 97

Blinking in 
Green

Warm-up in 
progress

(Not an error)
· Wait for a moment.
· The green lamp will stop blinking and 

become illuminated once the warm-up 
procedure has been completed.

37

Blinking in Red

Internal error

Cease operations, remove the Power Plug from 
the socket and contact your dealer or nearest 
address provided at page 121 and request 
repairs.

Extinguished

The power is not 
switched on

The power is not switched on.
· Check the power cord connection.
· Check the power supply to the socket.

36

Indicator Status

Cause

Recovery and Status

Reference 

Page

Illuminated in 
red

Time to replace the 
lamp.

Replace the lamp with a new one (ELPLP14).

Blinking in Red

Lamp error

· Replace with a new lamp (ELPLP14).
· Check to ensure that the lamp or fan are 

correctly attached if the lamp has been 
replaced. If the lamp or fan are not correctly 
attached, the projector will assume the same 
status as if the power has not been switched 
on.

· If the lamp is broken, take care to avoid injury 

and contact your nearest address provided at 
page 121 to request repairs (images cannot be 
projected unless the lamp is replaced).

111

Blinking in 
Orange

Nearing the time 
for replacing the 
lamp

Prepare a new lamp. It is recommended that 
the lamp is replaced as soon as possible, as 
there are cases where the time for replacement 
is earlier than stated in the conditions of usage.

111

Extinguished

(Not an error)
The power has not been switched on or nor-
mal projection is in progress.

Indicator Status

Cause

Recovery or Status

Reference 

Page