Epson 62c 사용자 설명서

Epson PowerLite 62c/82c Projector

9/05

Epson PowerLite 62c/82c Projector

5. Hold the lamp as shown and pull it straight out.

Note:

The lamp(s) in this product contain mercury. Please

consult your state and local regulations regarding disposal or
recycling. Do not put in the trash.

6. Gently insert the new lamp. If it doesn’t fit easily, make sure

it’s facing the correct way.

Caution:
Do not touch the glass portion of the lamp assembly. Touching
the glass could result in premature lamp failure.

7. Once the lamp is fully inserted, tighten its screws.

Note:
Be sure to seat the lamp fully and secure the lamp cover. If the
lamp is not properly installed or the cover is loose, the lamp will
not turn on.

8. Lower the lamp cover into place. Then slide the cover closed

and tighten the screw.

9. Reset the lamp timer as described on page 13.

Resetting the Lamp Timer

You must reset the lamp timer after replacing the lamp to clear
the

Replace the Lamp

warning message. Follow these steps:

Note:
Do not reset the lamp timer if you have not replaced the lamp. If
you do, the Lamp Hours will not accurately reflect the number of
hours that the lamp has been used.

1. Connect the power cable and turn on the projector.

2. Press the

button on the remote control or projector

and select the

Reset

menu. Then press

Enter

. You see the

following:

3. Select the

Reset Lamp Hours

option and press

Enter

. You

see the following:

4. Select

Yes

and press

Enter

5. Press

Esc

to return to the main menu or

to exit the

menu system.