Epson EB-W8D 사용자 설명서

8

Take note of the following advice in order to prevent malfunction and damage.

• Be sure to observe the operating temperatures 

and storage temperatures given in this guide 

when using and storing the projector.

• Do not set up the unit in places where it might 

be subjected to vibration or shock.

• Do not install the unit close to television, radio or 

video equipment that generates magnetic fields.

This may adversely affect the audio and images of 

this unit, and may cause a malfunction. In the event 

that such symptoms occur, move the unit further 

away from any television, radio and video 

equipment.

• Do not operate the projector under any of the 

following conditions. If this is not observed, 

problems with operation or accidents may result.

• Do not move this unit during playback.

This may damage the disc or cause malfunction.

• Avoid using or storing this unit in cigarette or 

other smoke filled places, or in rooms containing 

a large amount of dust.

This may cause degradation of the image quality.

• Do not touch the projection lens with your bare 

hands.

If fingerprints or marks are left on the face of the 

lens, the image will not be projected clearly. When 

the unit is not in use, be sure to attach the lens cover.

• EPSON will not be held responsible for damage 

arising from projector or lamp failure outside the 

range of that which is covered in your warranty 

terms.

• You can store the unit in an upright position 

compactly on a shelf, etc., as it has storage feet 

on its side. When storing the unit in an upright 

position, place it on a stable surface with the 

storage feet at the bottom. Be sure to place the 

unit in the storage case supplied with the unit so 

that no dust enters the air intake vent.

If you move this unit from a cold place into a warm 

room, or, if the room in which this unit is installed is 

heated rapidly, condensation (moisture) may form 

internally or on the lens surface. If condensation forms, 

it may not only cause incorrect operation such as 

weakening of the image, but also damage the disc and/

or parts. In order to prevent against condensation, setup 

this unit in the room approximately one hour before it is 

to be used. If by some chance condensation does form, 

disconnect the power cable from the outlet, then wait 

one to two hours before use.

A mercury lamp with high internal pressure is used as 

the unit’s light source.

The characteristics of the mercury lamp are:
• The intensity of the lamp decreases with use.
• When the lamp reaches the end of its life, it will no 

longer light or may break with a loud noise.

• The life of the lamp may vary greatly depending on 

the individual lamp characteristics and the operating 

environment. You should always have a spare lamp 

ready in case it is needed.

• Once the lamp replacement period has elapsed, the 

possibility of lamp breakage incrcases. When the 

lamp replacement message appears, replace the lamp 

with a new one as soon as possible.

• This product includes a lamp component that contains 

mercury (Hg). Please consult your local regulations 

regarding disposal or recycling.

Do not dispose of it with normal waste.

Notes on handling and storage

While the projector is 
standing on its end

While the projector is placed 
with the top facing up

While the projector is 
placed with the bottom up

While the projector is 
tilted to either side

Condensation

Lamp