JVC DLA-M5000LU 사용자 설명서
25
Basic Operations
■
Projector’s buttons
■
Remote control unit
OPERATE button
MAIN POWER switch
Projector’s indicator
2
,
1
1
,
2
Remote control unit
Projector
or
Example of the projector’s button
Projector
Projector
OPERATE button
2
,
1
1. Turning on the Power
STAND BY indicator
OPERATE indicator
* Do not turn off the MAIN POWER switch during cool
down mode (the STAND BY indicator blinking). About
10 minutes after the STAND BY indicator comes on
steady (stand-by mode), the cooling fans (except the
one for the light-source lamp power supply) will stop,
and then turn off the MAIN POWER switch.
10 minutes after the STAND BY indicator comes on
steady (stand-by mode), the cooling fans (except the
one for the light-source lamp power supply) will stop,
and then turn off the MAIN POWER switch.
\
STAND BY
OPERATE
LAMP
EMERGENCY
AV
RGB
TEMP
STAND BY
OPERATE
OPERATE
OPERATE
STAND BY
STAND BY
MEN
U/E
N
T
E
R
QUICK
ALIGN.
AV HIDE
OPERATE
PRESET
AV
SHIFT
ZOOM
FOCUS
LENS
U
T
+
D
W
–
RGB/COMPUTER
LENS
LOCK
UNLOCK
PAGE BACK
The following describes the basic procedure for normal use of
the projector.
the projector.
1
Turn on the MAIN POWER switch
of the projector.
of the projector.
ON [
❙
]:The main power turns on and the STAND BY
indicator comes on.
2
Press the OPERATE button for one
second or more.
(Or press the remote control’s
OPERATE button for one second
or more.)
second or more.
(Or press the remote control’s
OPERATE button for one second
or more.)
• The OPERATE indicator comes on.
• About 30 seconds after the MAIN POWER switch is
• About 30 seconds after the MAIN POWER switch is
turned on, you can start projecting.
Note
• After the power is turned on, the screen may be jumbled for a few
seconds, but this is not a malfunction.
■
Turning off the Power
1
Press the OPERATE button for one
second or more.
(Or press the remote control’s
OPERATE button for one second
or more.)
second or more.
(Or press the remote control’s
OPERATE button for one second
or more.)
• The STAND BY indicator changes to blinking, and the
projector goes into cool-down mode.
2
Turn off the MAIN POWER switch
after the cooling fans have
stopped running.
after the cooling fans have
stopped running.
OFF [
‡
‡
‡
‡
‡
]: The MAIN POWER switch turns off and the
STAND BY indicator goes off.
■
Caution on extended projection:
When projection continues for an extended amount of
time, be sure to allow the lamp to be turned off for at
least two minutes for every 72 hours of continued
projection.
If you do otherwise, the service life of the lamp may be
severely affected.
time, be sure to allow the lamp to be turned off for at
least two minutes for every 72 hours of continued
projection.
If you do otherwise, the service life of the lamp may be
severely affected.
M5000LU/SCU p.25-32
01.3.5, 15:07
25