JVC DLA-M5000LE 사용자 설명서

DLA-M5000CLE (Re)/ LCT0979-002A / ENGLISH

■ Projector’s buttons

■ Remote control unit

The following describes the basic procedure for normal use 
of the projector.

1 Turn on the MAIN POWER switch of the 

2 Press the OPERATE button for one second 

• The OPERATE indicator comes on.
• About 30 seconds after the MAIN POWER switch is 

turned on, you can start projecting.

• After the power is turned on, the screen may be jumbled for 

a few seconds, but this is not a malfunction.

■ Turning off the Power
1 Press the OPERATE button for one second 

• The STAND BY indicator changes to blinking, and the 

projector goes into cool-down mode.

2 Turn off the MAIN POWER switch after the 

* Do not turn off the MAIN POWER switch during cool 

down mode (the STAND BY indicator blinking). About 
10 minutes after the STAND BY indicator comes on 
steady (stand-by mode), the cooling fans (except the 
one for the light-source lamp power supply) will stop, 
and then turn off the MAIN POWER switch.

■ Caution on extended projection:

When projection continues for an extended amount of     
time, be sure to allow the lamp to be turned off for at 
least two minutes for every 72 hours of continued 
projection.
If you do otherwise, the service life of the lamp may be 
severely affected.

STAND BY

OPERATE

LAMP

EMERGENCY

AV

RGB

TEMP

STAND BY indicator

OPERATE indicator

OPERATE button 

2

, 

1

MAIN POWER switch 

1

, 

2

OPERATE button 

2

, 

1

MEN

U/E

N

T

E

R

QUICK

ALIGN.

AV HIDE

OPERATE

PRESET

AV

SHIFT

ZOOM

FOCUS

LENS

U

T

+

D

W

–

RGB/COMPUTER

LENS

LOCK

UNLOCK

PAGE BACK

 ❙ ]: The main power turns on and the STAND BY 

indicator comes on.

‡

‡

‡

‡]:The MAIN POWER switch turns off and the 

STAND BY indicator goes off.

STAND BY

OPERATE

OPERATE

or

STAND BY

OPERATE

\

STAND BY

DLA-M5000LE&SCE Eng Re.book  Page 24  Tuesday, March 12, 2002  3:59 PM