JVC Model 200 사용자 설명서

 

 

 

High Voltage points up to 40,000 volts 

are exposed inside the covers. Allow at least one minute for 
the high voltage to bleed off, even after power is turned off. 

certified service personnel! 

Due to high voltage danger, 

 

• 

CRT cables. These cables can cause severe shock from a 
tiny, invisible crack or hole and should never be touched 
while projector power is on. 

• 

CRT anodes. 

• 

Main power ± supply posts. 

• 

Arc Lamp main power ± posts. 

• 

CRT yoke assemblies and other proximity electrical 
assemblies, components and wiring. If performing the ILA

 

Back Focus, CRT Mechanical Focus, CRT rotation, or 
ILA

 Overlap adjustment, as outlined in Chapter 3, always 

use an ANSI/ASTM 10,000 volt rated glove. Periodically 
check the condition of the gloves for cracks. 

The projector operates from a 100V - 240V, 20 Amp, single-
phase, 50/60 Hz AC power source. Ensure local power source 
matches these requirements before operating! 

For continued safe and reliable operation, only use cables 
supplied by the manufacturer for power and signal connections. 

Certain components of the projector contain fluid. If any fluid from 
the projector contacts the skin, wash off with soap and water. If 
any fluid from the projector splashes into the eyes, rinse with cool 
running water. 

Model 200 Service Manual 

viii