JVC 335 사용자 설명서

 

Model 335 Supplement  

13

 

 

The Xenon Arc Lamp Lamphouse must be removed as a 
complete unit. Do not remove the arc lamp separately! 

To remove the Xenon Arc Lamp Lamphouse: 

1.  Turn power off and unplug the projector. Do not attempt to 
remove or replace the Lamphouse without first removing 
power by turning power off with the remote (or PC terminal) 
and the circuit breaker on the side of the System Power 
Supply and unplugging the projector from the AC wall outlet. 

2.  Disconnect the high voltage leads from the Ignitor (the two 
wires shown at the right in Figure 1). NOTE: DO NOT REMOVE 
THE CABLES FROM THE ARC LAMP-LEAVE BOTH CABLES 
ATTACHED TO PREVENT MISALIGNING THE ARC LAMP 
INTERIOR COMPONENTS. 

3.  Disconnect the fan connector on the left side of the 
Lamphouse. 

4.  Disconnect the squirrel cage blower connector on the right side 
of the Lamphouse. 

5.  Remove the two hex bolts on the right rear of the Lamphouse 
slide. 

6.  Carefully slide the Lamphouse out from the right side of the 
projector. 

Replace the Lamphouse in the reverse order.