Toshiba B-EX4T1 사용자 설명서

ENGLISH VERSION EO1-33089 

2.6 Printer Setting

E2-30 

 
 

 

 

 

 

 

 

 

 

 

 

How to enter the System Mode 
 
 
 
 
 
 
The System Mode consists of the following menus.  

<1>DIAG. 

Used to check and print the printer system information and 
maintenance counter status. 

<2>PARAMETER SET (

⇒ Section 2.6.2) 

Used to set the parameters for each printer function. 

<3>ADJUST SET (

⇒ Section 2.9) 

Used to fine adjust the print position, cut position, print tone, etc.  

<4>TEST PRINT (

⇒ Section 2.8) 

Used to perform print tests.

 

 

<5>SENSOR ADJUST  

Used to check the sensor statuses and set each sensor. 

<6>RAM CLEAR  

Used to perform a RAM clear.  DO NOT USE this menu. 

<7>INTERFACE (

⇒ Section 2.6.10) 

Used to set the interface parameters. 

<8>BASIC (

⇒ Section 2.6.4) 

Used to set the function of basic program when it is loaded to the 
printer. 

<9>FOR FACTORY  

Used for an in-process inspection.  DO NOT USE this menu. 

<10>RFID  

Used to set RFID related parameters. 

<11>RTC (

⇒ Section 2.6.11) 

Used to set the date and time of the real time clock, enable or disable 
the low battery check, and choose a real time renewal timing. 

<12>Z-MODE (

⇒ Section 2.6.5) 

Same as BASIC 

<13>USB MEMORY (

⇒ Section 2.6.12) 

Used to copy data to/from USB memory.  

<14>RESET 

Used to reset the printer. 

 

 

Power OFF

System Mode

Power ON while holding down 
[FEED]&[PAUSE]  

Power ON while holding down 
[MODE]