Datamax I-4206 사용자 설명서
I-Class
69
Standard Calibration (continued)
Step
Operator Action
Displayed Message
Comment
7
Proceed according to
your media type:
your media type:
Die-cut stock: strip the
media from the backing
and then reinsert it into
the sensor; adjust the
Sensor Eye Mark over
the center of the backing.
media from the backing
and then reinsert it into
the sensor; adjust the
Sensor Eye Mark over
the center of the backing.
Notched stock: adjust
the Sensor Eye Mark
over the center of the
notch.
the Sensor Eye Mark
over the center of the
notch.
Reflective stock: Adjust
the Sensor Eye Mark
over the center of the
facedown black mark.
the Sensor Eye Mark
over the center of the
facedown black mark.
Continuous stock: go to
Step 8.
Step 8.
Press any key to
continue.
continue.
TDBO!CBDLJOH
QSFTT!BOZ!LFZ!!!=zzz?
Or, for reflective media:
TDBO!NBSL
QSFTT!BOZ!LFZ!!!=zzz?
This sets the
parameter for the
‘gap’ or ‘mark’
value.
parameter for the
‘gap’ or ‘mark’
value.
Where ‘yyy’ is a
numerical value
representing the
current sensor
reading: useful in
locating the best
sensor position.
numerical value
representing the
current sensor
reading: useful in
locating the best
sensor position.
;
Note: Never
position the
sensor over a
perforation when
recording a
sensor reading.
perforation when
recording a
sensor reading.
;
Note: Do NOT move the position of the Media Sensor after it has been
adjusted.
8
Position the label (and
backing, if any) under
the Sensor Eye Mark.
backing, if any) under
the Sensor Eye Mark.
;
Note: If using
preprinted media,
ensure the label area
ensure the label area
under the sensor is
free of preprinted text,
graphics or borders.
free of preprinted text,
graphics or borders.
Press any key to
continue.
continue.
TDBO!QBQFS
QSFTT!BOZ!LFZ!!=zzz?
This sets the
parameter for the
‘paper’ value.
parameter for the
‘paper’ value.
Where ‘yyy’ is a
numerical value
representing the
current sensor
reading.
numerical value
representing the
current sensor
reading.