Xerox N17b 사용자 설명서
Loading Paper
Chapter 4: Paper Loading and Orientation
❖
4-21
3
Stack the envelopes face up with the stack against the
feeder’s left edge.
feeder’s left edge.
For PCL applications: The corner for the return address
should be on the left side of the stack and trailing as the
envelopes go into the printer (as shown at left).
should be on the left side of the stack and trailing as the
envelopes go into the printer (as shown at left).
For PostScript applications: Some PostScript applications
require that the envelopes be loaded with the return
address corner on the right side of the stack and leading
as the envelopes go into the printer. Test your application
for proper orientation.
require that the envelopes be loaded with the return
address corner on the right side of the stack and leading
as the envelopes go into the printer. Test your application
for proper orientation.
Push the envelopes gently into the printer. Do not
force the envelopes between the last two rollers
(the two that touch), as this may cause a jam to
occur.
force the envelopes between the last two rollers
(the two that touch), as this may cause a jam to
occur.
4
Adjust the side guide against the right side of the stack
and lower the envelope holder.
and lower the envelope holder.
Do not stack envelopes higher than the red “full”
line on the side guide, nor push the side guide so
hard against the stack as to deform the envelopes.
line on the side guide, nor push the side guide so
hard against the stack as to deform the envelopes.
5
Because the Envelope Feeder does not have a paper size
sensor, you must tell the printer which size envelope is
loaded via the Envelope Size item in the Control Panel’s
Tray Menu. The type of envelope (plain, prepunched,
letterhead, transparency, etc.) must also be set, using the
Tray Menu’s Envelope Type item.
sensor, you must tell the printer which size envelope is
loaded via the Envelope Size item in the Control Panel’s
Tray Menu. The type of envelope (plain, prepunched,
letterhead, transparency, etc.) must also be set, using the
Tray Menu’s Envelope Type item.
See Chapter 3: Using the Control Panel for instructions on
accessing menus.
accessing menus.
With the Envelope Feeder installed, the MBF may
still be used.
still be used.