Epson 7000 사용자 설명서
EPSON Stylus Pro 7000
Revision B
Disassembly & Assembly
Disassembly Flow
132
4.2.3.4 Removing the CR Board Assembly
1.
Remove the R Side Cover as described in “R Side Cover Removal” on
page 114.
page 114.
2.
Remove the L Side Cover as described in “L Side Cover Removal” on
page 116.
page 116.
3.
Remove the I/C Holder Cover as described in “I/C Holder Cover Removal”
on page 116.
on page 116.
4.
Remove the H Top Cover as described in “H Top Cover Removal” on
page 117.
page 117.
5.
Remove three screws (CPPM3x6) securing the CR board, and remove one
screw (CP(W)M3x6) securing the ground line, washer (M3), and CR board
guide.
screw (CP(W)M3x6) securing the ground line, washer (M3), and CR board
guide.
Figure 4-38. CR Board Guide Removal
6.
While holding down the CR Board (left edge), remove two FFC cables
from the FFC lock-type connectors.
from the FFC lock-type connectors.
Figure 4-39. CR Board FFC Removal
7.
While holding down the CR Board (left edge), remove three connectors
from the CR Board.
from the CR Board.
Figure 4-40. Connector and CR Board Removal
8.
Remove two screws (CPP M3x8), then remove the CR Board.
You may find it helpful to manually release the Carriage Lock
by pushing down the cutter and move the carriage away from
the capping position.
by pushing down the cutter and move the carriage away from
the capping position.
CR board guide
Screw,
ground
line, and
washer
Three screws
FFC to Main Board
FFC to printheads
CR Board
Connector (white,
to CR encoder)
Connector (black, to
P_Edge sensor)
Connector (white, to
cutter solenoid)
Two
screws
Ground,
washer
CR Board