Epson 7000 사용자 설명서

This function corrects the gap between the B head and the C head. The 
adjustment pattern is printed in one direction, and referring to the printed test 
patterns, you can correct any gap between the heads. The adjustment items 
are as follows.

Note: The number refers to the numbered pattern on the printed Bi-D test pattern.

1.

Make sure "Adj: Head LR Adj." appears in the LCD, and press the Enter 
button. After all the patterns print, "Gap, 200, N: vvv" appears in the LCD.

2.

At this point, you need to check the alignment of the lines on the printed 
test pattern.

„

If the lines are correctly lined up as in the above sample, (make sure 
"Gap Check End" appears in the LCD and) press the Enter button to 
finish.

„

If some lines are not aligned, select the numbered pattern using the 
Paper Feed +/- buttons.
Correction distance:

One press = 1/2880 inch

Correction direction:

"+" = toward HP and "-" = away from HP

Aim =

Black and light cyan lines are vertically
aligned

After you finish correcting a pattern, press the Enter button to print 
another test pattern of that number only with your new settings in 
effect.

3.

 Repeat the steps until all numbered patterns are aligned.

Gap/200/N

Gap adjustment/200cps/Normal-Dot

9

Gap/200/M

Gap adjustment/200cps/Micro-Dot

10

Gap/300/N

Gap adjustment/300cps/Normal-Dot

11

Gap/300/M

Gap adjustment/300cps/Micro-Dot

12