Epson 7000 사용자 설명서
EPSON Stylus Pro 7000
Revision B
Adjustment
Self-Diagnostic Mode Menus
194
COUNTER CLEAR
This function resets (to the original condition) the following counters which
are stored in memory on the Main Board.
are stored in memory on the Main Board.
Note *: "1" means the flag is set, and the next time power is turned on the printer
will perform an initial ink charge.
5.4.3 Cleaning Menu
Using this menu you can select a cleaning mode and initiate that cleaning
operation. Also you can select whether or not the printer performs the initial-
cleaning cycle as well as forcefully start the initial-cleaning cycle.
operation. Also you can select whether or not the printer performs the initial-
cleaning cycle as well as forcefully start the initial-cleaning cycle.
Figure 5-41. Cleaning Menu Options
Std. KK0 (CL1)
Normal cleaning cycle
Normal cleaning cycle
Volume of ink cleared = low
Std. KK1 (CL1’)
Strong cleaning cycle
Strong cleaning cycle
Volume of ink cleared = medium
rubbing = off
rubbing = off
Std. KK2 (CL2)
Strong cleaning cycle
Strong cleaning cycle
Volume of ink cleared = high
rubbing = on
rubbing = on
Init. Fill
Perform Initial charge sequence
Table 5-14. Counters Reset by "Counter Clear"
Counter
Reset Value
Protection Counter A/B
0
Ink Volume Counter Rb/ Ry/ Rx/Rz
0
Consumed Ink Counter Cb/ Cy/ Cm/ Cc/ Cll/ Clc
0
Power Cutoff Timer T2
0
Accumulated Prints Timer
0
CL Timer
0
CL Timer 3
0
CL Flag
0
Initial Charge Flag
1*
Periodic Pseudo-Vacuum Flag
0
C A U T I O N
Before clearing the Waste Ink Counter or the Consumed Ink
Counter, make sure you replace the following parts with new
parts.
Counter, make sure you replace the following parts with new
parts.
Waste Ink Pads
Flush Box
Pump Assembly
Cap Assembly
Head Cleaner
The above parts are provided as [Maintenance Kit, SP-7000
1054038].
1054038].
[Pause] returns you
to previous menu
[SelecType]
[Item]
[Enter]
Start the
cleaning cycle
Cleaning: Std. KK0
Cleaning: Std. KK1
Cleaning: Std. KK2
Cleaning: Init. Fill