Printek 4503 사용자 설명서
ANSI X3.64 Emulation
Page 2-14
Emulations
Select Software Interface n
ESC ESC
n
Selects the software interface n according to the table below.
n
Software Interface
0
Test (reserved for factory use)
1
ANSI X3.64 Emulation
2
Epson FX Emulation
3
Bar Code Mode (optional)
4
IBM Proprinter Emulation
5
DEC LA120 Emulation
6
TTY Emulation
7
Printek Emulation
?
Previously Selected Emulation
@
Default Emulation
Overrides the "Mode:" value in the "Setup: INTERFACE" menu. "Mode:
BarberPole" and "Mode: Hex Dump" cannot be overridden.
BarberPole" and "Mode: Hex Dump" cannot be overridden.
A numeric value for n may be specified in two different ways, with equivalent results:
a single byte with a value of 00 to 07 hex, or a single printable ASCII character "0" to
"7" (30 to 37 hex).
a single byte with a value of 00 to 07 hex, or a single printable ASCII character "0" to
"7" (30 to 37 hex).
If more than one emulation has been selected, ESC ESC ? will return to the
previously selected emulation. This is particularly useful when the previous
emulation is unknown. Please beware that the memory (stack) is only one level deep.
previously selected emulation. This is particularly useful when the previous
emulation is unknown. Please beware that the memory (stack) is only one level deep.
ESC ESC @ will return to the default emulation, as specified by the "Mode:" value in
the "Setup: INTERFACE" menu.
the "Setup: INTERFACE" menu.
This chapter describes ANSI X3.64 emulation. If a different interface is selected, the
control codes and escape sequences described in this chapter will no longer be
applicable.
control codes and escape sequences described in this chapter will no longer be
applicable.
Example: The following escape sequences will select Printek emulation, load form
one, and then return to the previous emulation.
one, and then return to the previous emulation.
Escape Sequence:
ESC ESC
7
ESC
L
1
ESC ESC
?
Hexadecimal:
1B
1B
07
1B
4C
01
1B
1B
3F