Intermec PF4i 사용자 설명서

⇐

⇒

Maximum: 114.3 

mm 

(4.50 

inches)

Minimum (standard): 

25.0 mm  (1.00 inches)

Min. (narrow Quick-Load):  40.0 mm  (1.57 inches)
Min. (wide Quick-Load): 

80.0 mm  (3.15 inches)

⇐

⇒

Minimum: 20.0 

mm 

(0.8 

inches)

Maximum:                           depends on SDRAM size

⇐

⇒

Five fi xed positions, see Chapter 12.

⇐

⇒

The detectable width of the black mark should be at least 5.0 mm (0.2 
inches) on either side of the LSS detection point.  

⇐

⇒

Maximum: 21.3 

mm 

(0.83 

inches)

Common: 12.5 

mm 

(0.5 

inches)

Minimum: 5.0 

mm 

(0.2 

inches)

⇐

⇒

It is recommended that you place the black mark as close to the front 
edge of the ticket as possible and use a negative Stop Adjust value to 
control the media feed, so the tickets can be properly torn off.

• Ticket (w mark) 

Note: Preprint that may interfere with the detection of 
the black mark should be avoided. However, the Intermec 
Fingerprint statement LBLCOND allows the sensor to be 
temporarily disabled during a specifi ed amount of media feed 
in order to avoid unintentional detection, see Intermec Finger-
print manuals. 

Note: The black mark should be non-refl ective carbon black 
on a whitish background. Do not allow any perforations to 
break the edge of the media as this may cause the media to split 
and jam the printer.