Intermec PF4i 사용자 설명서
Intermec EasyCoder PF4i Compact Industrial—User’s Guide (Fingerprint)
57
Chapter 6—Setting Up the Printer
Paper Type
The Paper Type parameters control the heat emitted from the printhead
to the direct thermal media or, optionally, the transfer ribbon in order to
produce the dots that make up the printout image.
to the direct thermal media or, optionally, the transfer ribbon in order to
produce the dots that make up the printout image.
Labels, tickets, tags, strip, and ribbons for various types of application
are available from Intermec. For the best printout quality and maximum
life of the printhead, use Intermec supplies. Setup recommendations
for Intermec supplies offered in Europe and North America are listed in
Appendix D.
are available from Intermec. For the best printout quality and maximum
life of the printhead, use Intermec supplies. Setup recommendations
for Intermec supplies offered in Europe and North America are listed in
Appendix D.
As a general rule, high energy and/or high print speed will shorten the
life of the printhead. Never use higher paper type and print speed set-
tings than necessary for obtaining an acceptable printout quality and
throughput speed.
life of the printhead. Never use higher paper type and print speed set-
tings than necessary for obtaining an acceptable printout quality and
throughput speed.
If the ambient temperature is lower than +15°C (+59°F), decrease the
print speed by 50 mm/sec.
print speed by 50 mm/sec.
Start by choosing between two alternatives:
• Direct
Thermal printing
(option)
• Thermal Transfer printing
(default)
Your choice will decide which parameters to enter next:
Direct Thermal Printing
• Label Constant
(range 50 to 115)
• Label Factor
(range 10 to 50)
When adjusting the image darkness for non-Intermec direct thermal
media, set the Label Factor to the recommended value for the type of
direct thermal media. Set the Label Constant to the value listed below
and decrease or increase it for lighter or darker images respectively until
you are satisfi ed with the printout quality.
media, set the Label Factor to the recommended value for the type of
direct thermal media. Set the Label Constant to the value listed below
and decrease or increase it for lighter or darker images respectively until
you are satisfi ed with the printout quality.
General Paper Type Settings Guide (Direct Thermal)
Sensitivity
1
Label
Label
Max Print Speed
Constant
Factor
8 dots/mm
11.81 dots/mm
Low 100
40
100
100
Standard 90
40
125
125
High 80
40
175
150
Ultra high
60
40
200
150
1
/. Note that preprint and varnish decrease the sensitivity of direct thermal media.