Genicom PC4 사용자 설명서

Media Load

Introduction

The EasyCoder PC4 can print on heat-sensitive direct thermal paper, and 

in case of the thermal transfer model also on non heat-sensitive receiving 

face materials, in the form of self-adhesive labels, non-adhesive tags, or 

continuous stock. In case of non heat-sensitive face materials, a suitable 

thermal transfer ribbon must be used. 
The media stock can be accommodated inside the printer in the form of 

a roll, or be placed behind the printer and inserted through a slot in the 

cover (for example fan-folded tickets or tags). 
Three types of operation are available, Tear-Off (Straight-through), Peel-

Off (Self-Strip), and Cut-Off: 

Tear-Off 

Tear-off (Straight-through) means that the media is fed straight out 

from the front of the printer and can be torn-off manually by pulling 

it upwards against the edge on the top cover. Tear-off mode can, for 

example, be used for tearing off tags at the perforation, or tearing off the 

liner (backing paper) between labels.

Peel-Off

Peel-off (Self-strip) means that self-adhesive labels are automatically 

separated from the liner (backing paper) after printing. It cannot be used 

in connection with a paper cutter. The labels are fed straight out from the 

printer, whereas the liner is fed out separately from a slot further down 

on the printer’s front, from where it can be lead to for example a waste 

basket. Be careful when loading self-adhesive labels. If labels are not 

flat on the liner, the exposed edges can stick to your printer and cause 

problems.

Cut-Off

Cut-off requires an optional paper cutter fitted in place of a peel-off 

device and means that the liner of self-adhesive labels is automatically 

cut between labels or non-adhesive contionuous strip is cut into tickets 

and tags. The cutter is not designed to cut through any adhesive, which 

would stick to the cutting shears and prevent the cutter from operating.