Genicom PC4 사용자 설명서

The Intermec EasyCoder PC4 printers are manufactured and tested 

under a strict quality management program. Only high quality com-

ponents and materials are used in the printers. Although only minimal 

maintenance is required, following these simple maintenance procedures 

will ensure longer life with quality printing performance.

External Cleaning

Keep your EasyCoder PC4 clean by periodically wiping it with a soft 

cloth dampened with water. Do not use abrasive cleaners or solvents as 

they will scratch the surface.

Printhead Cleaning

We recommend using the special Cleaning Card (part number 

1-110501-00) and the procedures below to clean the printhead before 

loading each new roll of labels or tags.

  Switch off the power to the printer.

  Open the top cover/print carriage.

  Unload the media stock.

  In case of thermal transfer printing, also remove the transfer ribbon.

  Open the pouch and pull out the cleaning card. Be careful not to tear 

the card inside!

  Insert the cleaning card under the print carriage the same way as when 

loading the media. Allow approximately 2 to 3 cm (1 inch) of the 

cleaning card to extend in front of the printhead.

  Fold down the print carriage to locked position.

  Use one hand to hold the printer and the other hand to pull the clean-

ing card forward, until the entire card has been pulled free.

  Repeat steps 6, 7, and 8 a second time, then proceed at step 10.

 Dispose properly of the used cleaning card and reload the media and 

ribbon supplies.