Genicom GEK 00031B 사용자 설명서
GEK-00029B
5000 Series Programmer’s Manual
15
FF
Form Feed (0CH): Line terminator. The paper is advanced to the
next
top-of-form position. When the EVFU is enabled and programmed, paper
will advance to the next stop in channel 1.
will advance to the next stop in channel 1.
HT
Horizontal Tab (09H): Advances the print position to the next
horizontal tab location. If no tabs are set, an HT code is either converted to a
space or ignored, depending on the menu option settings.
space or ignored, depending on the menu option settings.
LF
Line Feed (0AH): Line terminator. The paper is advanced to the
next
line. When printing horizontal dot graphics, the paper is advanced to the next
dot row.
dot row.
SI
Shift In (0FH): Used to exit a Special Print Mode (GENSPM) when
ANSI emulation strap 1 (Appendix G, tables 5 and 6) is active.
SO
Shift Out (0EH): Used to enable a special print mode (GENSPM)
when
ANSI emulation strap (Appendix G, tables 5 and 6) 1 is inactive.
VT
Vertical Tab (0BH): Line terminator. The paper is advanced to
the
next vertical tab stop. If no tabs are set, a VT code causes a line feed. When
using the EVFU, paper advances to the next stop in channel 12.
using the EVFU, paper advances to the next stop in channel 12.
NOTE
An option strap from the CCU Control Panel Menu using the
SETUP/FORMAT/MODIFY FORMAT/GENPRTOPTS selection
SETUP/FORMAT/MODIFY FORMAT/GENPRTOPTS selection
can disable this feature.
(See note for <FF>, above.)
(See note for <FF>, above.)