Genicom microLaser 210 사용자 설명서
Mar 00
Genicom
Publication No. GEG-99054
microLaser 210 User Guide
4-19
Cleaning the Printer
4.
Verify that the power switch of the printer is in the [O] (off) position, then insert the plug of
the power cord into the AC outlet.
the power cord into the AC outlet.
5.
Turn the printer on by pressing [ I ] on the power switch on the right side of the printer.
Cleaning the Interior
The interior of the printer does not generally need to be cleaned unless a paper jam drops toner
onto the paper path or you accidentally spill toner inside the printer when installing a new toner
cartridge. Use the following procedure to clean the interior of the printer only when necessary:
onto the paper path or you accidentally spill toner inside the printer when installing a new toner
cartridge. Use the following procedure to clean the interior of the printer only when necessary:
Since there is always the possibility of damaging delicate printer components by careless-
ness or vigorous cleaning methods, GENICOM recommends that you clean the interior only
when you are instructed to do so by a service representative or in a troubleshooting proce-
dure presented in this manual.
ness or vigorous cleaning methods, GENICOM recommends that you clean the interior only
when you are instructed to do so by a service representative or in a troubleshooting proce-
dure presented in this manual.