Zebra Technologies P1013372-001 REV. A 사용자 설명서
98
Zebra ZXP Series 8 Card Printer with Laminator
P1013372-001 Rev. A
ZXP Series Toolbox
Cleaning
Clean Laminator
, for cleaning via the OCP.
•
Card transport Rollers
When you click on the Clean button, instructions will appear in the following sequence:
1.
Open the laminator cover, remove the laminate (top and bottom cassettes), and close
the cover. Then, click Ok.
the cover. Then, click Ok.
2.
Wait until the laminator temperature goes below 60
o
.
3.
Remove the card hopper, and click Ok.
4.
Insert the Laminator Cleaning Card in the side slot where the card hopper was located.
Click Ok after inserting the cleaning card.
Click Ok after inserting the cleaning card.
5.
Wait until the cleaning process completes. The card will eject through the laminator
side slot.
side slot.
6.
Observe the message, Laminator cleaning successful.
7.
Open the laminator cover, install the laminate (top and bottom spools), and close
the cover.
the cover.
•
Heater Rollers (see