Zebra Technologies P640i 사용자 설명서
![Zebra Technologies](https://files.manualsbrain.com/attachments/a78f49d565a2596a8b31f4240e25fed2998da2a0/common/fit/150/50/2656e56263d759e2c7910989c000585d7bce0fb5d50f1f63705e38675fa7/brand_logo.gif)
980541-001 Rev. A
P640i Card Printer User Guide
43
Horizontal Offset
Override Defaults: This is to prevent accidental
modification of the offset number, which should not
need attention in regular use.
modification of the offset number, which should not
need attention in regular use.
Horizontal (X) Offset (Pixels: Adjusts where the
printer starts looking for a mag stripe. It is a manual
fine tuning of the value determined by the Mag
Position Adjust routine. It is intended only for testing
and diagnosis.
printer starts looking for a mag stripe. It is a manual
fine tuning of the value determined by the Mag
Position Adjust routine. It is intended only for testing
and diagnosis.
Start
> Printers (or Printers and Faxes) > Right click
Zebra P640i > Properties > Device Settings > Printer
Adjustment >
Adjustment >
Advanced Adjust
Magnetic Encoding Preferences
Start
> Printers > Right click Zebra P640i > Printing
Preferences >
Magnetic Encoding
Encoding choices and track layout
Mag Encoder Verify On
If this box is checked, every card is run twice under
the read/write head. The first pass writes the code, and
second reads it to check for accuracy and readability.
Any card not passing this test is ejected through the
laminator without printing. Verification adds only 3
seconds to the processing time per card, and is
recommended for all applications not calling for the
highest possible throughput.
the read/write head. The first pass writes the code, and
second reads it to check for accuracy and readability.
Any card not passing this test is ejected through the
laminator without printing. Verification adds only 3
seconds to the processing time per card, and is
recommended for all applications not calling for the
highest possible throughput.
Bit by Bit Encoding
This is used only in applications calling for a custom
designed encoding format. Call Zebra tech support for
more information.
designed encoding format. Call Zebra tech support for
more information.
Enable EIN Reedback
Applicable only in applications using cards with pre-
en-coded (“embedded”) inventory numbers.
en-coded (“embedded”) inventory numbers.
Track
Density
(bits/inch)
ISO format
AAMVA format
Data Type
Length*
Data Type
Length*
1
210
Characters
76
Characters
79
2
75
Numerals
37
Numerals
37
3
210
Numerals
104
Characters
79
* Not including start sentinel, end sentinel, or LRC characters