Zebra Technologies UMAN-QLP-001 사용자 설명서

QL Plus Series User Guide

0336

Important Notice:
This device is a portable RF printer intended
for commercial and industrial use in all EU
and EFTA member states except in France
where restrictive use applies.

Zebra 802.11b WLAN Radio Module

The following section only applies when the Zebra 802.11b WLAN radio module
(With FCC ID: I28MD-ZLAN11B) is installed in a QL Plus series printer (note that only one of the radio op-
tions can be installed in the printer at one time). Other than conditions specified elsewhere in this manual,
only one of the radio options can be installed in the printer at one time and the antenna used for these
transmitters must not be co-located or must not operate in conjunction with any other antenna.
QL Plus models have the FCC ID number on a label on the back of the unit.

Caution • The radiated output power of this internal 802.11b radio

is far below the FCC radio frequency exposure limits. Nevertheless,

this radio must be used in such a manner that the antenna is 2.5 cm.

or further from the human body. The radio and antenna are mounted

internally in this printer such that when the printer is worn with the

back of the printer against the body and the front of the printer (where

paper exits) away from the body, then the 2.5 cm distance between

the antenna and the users body will be met. Do not use the printer in
an unauthorized manner.

European Regulatory Information for this Radio

Note: -Member states in the EU with restrictive use for this device are crossed
out!
This device is also authorized for use in all EFTA member states (

CH, IS, LI, NO)