Zebra Technologies 3ULQWHUV 사용자 설명서

Print Mode Choices

Zebra XiIIIPlus Users Guide 

29

Peel-Off Mode advances one label at a time. The printer does not print another label 
until the first label is removed. The TAKE LABEL light flashes until the label is 
removed. The liner is wound on the rewind spindle, but the rewind plate is not used.

Remove the rewind plate (if installed) from the front of the printer. Store it on the 
two mounting screws on the inside of the front panel.                                         

Open the printhead.

Slide the media guide and media supply guide as far from the printer frame as 
possible. Flip down the media supply guide.

Start by loading labels as shown in 

.

When loading labels, allow approximately 36 in

.

 (915 mm) of labels to extend past 

the tear-off/peel-off bar. Remove all labels from this portion to create a leader.

Remove the hook from the rewind spindle. If you are using a core, slide it onto the 
rewind spindle until it is flush against the guide plate.

Wind the label liner around either the 3 in. (76 mm) core or the rewind spindle and 
reinstall the hook.

Flip up the media supply guide. Slide in the media guide and media supply guide 
so they just touch, the edge of the labels. The labels should lie flat.

Before closing the printhead, make sure:

• The labels are positioned against the inside guides.

• The labels are taut and parallel with the pathway when wound onto the rewind 

spindle or core.

Media supply guide

Labels

Guide plate

Spindle hook

Rewind spindle

Rewind plate